This will reduce the cost of the production of the hot Melt part

The fifth step is to set up the simulation as the seventh step in the process of the hot-melt high polymer fabrication. This step is necessary because the simulation is used to determine the parameters that need to be adjusted or that need to be changed in the process of making the foam.

The final step in the process of choosing the foam to use as the absorber for the hot-melt process is to choose the appropriate PMMA foam as the wet spinning component for the carbon fiber. The wet spinning component of the carbon fiber is necessary because wet spinning will help to uniformly distribute heat uniformly wave-transmitting foam Manufacturers through the carbon fiber structure during the manufacturing of the hot-melt high-performance carbon fiber part.

Once the carbon fiber wet spun has been formed, the foam can then be formed by passing it through the carbon fiber rollers as the final step in the process. When this final step is complete, the wet spun foam can then be used to manufacture the exterior surface of the hot-melt part. The foam ceramics that are used in the manufacturing process described above will reduce the amount of heat that is lost during the manufacture of the hot Melt carbon fiber part.

This will also reduce the amount of heat that escapes from the part during the cooling period after the part has been formed. In addition, the foam that is formed with the use of PMMA foam will help to absorb all of the energy that is radiated from the hot part. This will reduce the cost of the production of the hot Melt part and it will also reduce the amount of energy that is wasted during the cooling period. This will also help to maintain the peak performance of the part over time.

The top layer polymer mortar is used to level the nail cap

After the construction of the extruded board and the expansion nails are completed and passed the inspection and acceptance by Party A and the supervisor, apply a special interface agent evenly with a brush within 50mm of the expansion nail cap and circumference.

After the interface agent is air-dried, the top layer polymer mortar is used to level the nail cap. It is required that the position of the plastic expansion nails and the nail caps are leveled with polymer mortar, and the surface is level with the large extruded board.

Note: The purpose of this is to avoid that the top hat position is too thick due to the surface layer polymer bonding mortar, and the surface layer after survival will appear to Radom foam Manufacturers flow and shrink in the future.

After the polymer mortar at the position of the plastic expansion nails and nail caps is dried, apply the special interface agent evenly on the surface of the extruded board with a roller.